This website uses cookies to ensure you get the best experience on our website.

CP-SL06K

Solar Panel Kit with built-in Battery

  • The maximum power output is 30W.
  • Backup time 12 Hours (Assumption based on 76.8Wh Battery Capacity and 5.5 Watt continuous load)
  • Indications LED Battery charging: Green Blink
  • Indications LED Full charge: Green ON
  • Indications LED Battery discharge: Red ON
Datasheet

Cell Type Monocrystalline
No. of cells 32
Open circuit voltage 22.9 V+/- 10%
Short circuit current 1.59 A +/-
Voltage at Maximum power 19.25 V +/- 10%
Current at Maximum power 1.56 A +/- 10%
Maximum Power 30 W
Nominal Operating Cell Temperature 45 °C ± 2 °C
Panel operating Temperatures -20 °C to +65 °C
Superstrate High transmission low iron AR Coated tempered glass
Dimensions 510mm x 425mm x 17mm
Charge current Up to 1.5 A (Depends on Solar irradiation and Battery SOC)
Configuration 4S-1P
Capacity 76.8Wh
Nominal Voltage 12.8V
Discharge Cutoff Voltage 10V+/-10%
Charge Cutoff Voltage 14.6V +/- 10%
Cycle Life 1000 @ 90% DOD
Working Temperature 0°C~60°C (Discharge), 0°C~45°C (Charge)
Battery packaging PVC Sleeve
Weight 590(±15) g
Dimension 70 mm x 130 mm x 35 mm (±10) mm
Voltage During Charging 12V (+/-10%), Will be adjusted slightly based on Cable length
Voltage During Discharging 12V (+/- 10%), Will be adjusted slightly based on Cable length
Maximum Load Current During Charging 1A
Maximum Load Current During Dis-Charging 1A
OverLoad and Short circuit protection on Output 1.2 A Using PTC
Cable Length 3 Mtr.
Load 12 Watt Camera load (Load varies from 2.65 Watt to 10
Full charge time 6 to 7 Hours at 90% Irradiation (Depends on Solar irradiation and )
Backup time 12 Hours (Assumption based on 76.8Wh Battery Capacity and 5.5 Watt continuous load) Battery backup may vary based on the change in Power consumption
LED 1.Battery charging: Green Blink 2.Full charge: Green ON 3.Battery discharge: Red ON
Over all device level protections 1.Over voltage 2.Transient protection on input side 3.Higher efficiency and less self heat generation 4.Over current protection 5.Short circuit protection
Battery primary protection Using a separate PCB inside the battery pack to protect from all kinds of faults and issues men t ioned below. 1.Over current and Short circuit protection 2.Over voltage protection 3.Under voltage protection 4.Over charge protection 5.Deep discharge protection 6.Over temperature protection
Fasteners U-Bolt – 101.6 mm, Hose Clamp – 150 mm
Dimension. 550 mm x 450 mm x 105 mm
Output port Cable with compatible Power jack
ok
Start Your Training